Shopping Cart

All Categories

Showing 145–154 of 154 results

JMS CONVERSION KIT

The JMS CONVERSION KIT has everything you need to upgrade to the JMS (Jetter Management System). Wire harness, control panel, remote are all included. It is easy to install on site, with only a few hours of downtime. The JMS makes operating and servicing your jetter easier with its built in fault system that alerts the operator where the problem is within the jetter. This allows for more specific diagnoses and faster resolutions.

KARTECH 2 BUTTON REMOTE SYSTEM

The KARTECH 2 BUTTON REMOTE SYSTEM is a user friendly, Gen II wireless upgrade for jetters 2016 and older. The panel works with Hatz diesel engines equipped with a two speed throttle solenoid and mounts externally to existing US Jetting control panels without drilling mounting holes. The durable hand held remote is made of impact resistant plastic with an internal antenna and has water ON/OFF function plus an emergency engine stop button.

WARTHOG OIL SYRINGE

$30.00

The most important item in maintaining WARTHOG NOZZLES is keeping the tool full of viscous fluid. We recommend that this is done after every 40 to 50 hours of operation. If the nozzle is spinning much faster than when new, this is an indication that it needs to be lubricated with WARTHOG SLOW OIL. The WARTHOG OIL SYRINGE will be needed to fill the nozzle.

$30.00Add to cart

WARTHOG SLOW OIL

$20.00

The most important item in maintaining WARTHOG NOZZLES is keeping the tool full of viscous fluid. We recommend that this is done after every 40 to 50 hours of operation. If the tool is spinning much faster than when new, this is an indication that it needs to be lubricated with WARTHOG SLOW OIL.

$20.00Add to cart

WARTHOG FAST OIL

$20.00

The most important item in maintaining WARTHOG NOZZLES is keeping the tool full of viscous fluid or oil. We recommend that this is done after every 40 to 50 hours of operation. If the tool is spinning much slower than when new, this is an indication that it needs to be lubricated with WARTHOG FAST OIL.

$20.00Add to cart

1/2″ FIXED SWAGE FITTING

$30.00

The 1/2″ MENDER SWAGE FITTING mends two portions of hose together. Rated for 4000PSI.

$30.00Add to cart

1/2″ MALE SWIVEL SWAGE FITTING

$20.00

This swivel includes a male end coupling. The MPT swivel connects the dogbone to high pressure hose on standard units rated for 4000PSI.

$20.00Add to cart

1/2″ MENDER SWAGE FITTING

$30.00

The 1/2″ MENDER SWAGE FITTING mends two portions of hose together. Rated for 4000PSI.

$30.00Add to cart

1/2″ FEMALE SWIVEL SWAGE FITTING

$22.00

The 1/2″ SWIVEL SWAGE FITTING has FTP swivel coupling. The female swivel connects the high pressure hose to leader hose. Rated for 4000PSI.

$22.00Add to cart

HOSE MENDING TOOL

$1,969.00

The HOSE MENDING TOOL is an easy to use hydraulic machine that swages both menders (splices) and high pressure jetting hose end fittings. The machine uses industry standard heat treated and tapered dies. It comes complete with one set of dies (specify 1/2”, 5/8”, 3/4” or 1”), male end pusher, and jack handle. Additional die sets available.

$1,969.00Add to cart

Newsletter